![]() ![]() All they explain is the most basic task of sending images from LR to Helicon and rendering a simple stack. Yeah, well I have viewed several hours of youtube videos including the ones specifically from Helicon. It simply tells you how to send images from LR to Helicon and do the most basic steps to render a simple stack. If you read it you will not it gives zero information about my question. Your second link takes me to something I must have read 30 times already. Your first link is a post from me on the Helicon forum. Yes, I stated I read all the documentation available and I did. This is probably superfluous, but here are some descriptions of the issue: ![]() It does occur to me that maybe it is possible the functionality I am seeking is not possible. I keep thinking I must be missing something obvious and fundamental but I can't figure it out. I am hoping someone here is using Helicon and doing batch processing with images exported from LR to Helicon and can tell me what I am doing wrong. I have a pile of images (several thousand) in LR to be stacked. However that is not my preference for a whole host of reasons. Yes I know I could do all of this outside LR and then put the rendered images into LR to keyword and keep them organized. ![]() Keeping in mind that at the end of this process the whole point is for the rendered images to be autosaved back into LR after the stacks are rendered. I have no idea what location in Helicon has the images once they are exported from LR via the plugin. I think the problem is I have no idea and can not find the pathway the images take once they land in Helicon from LR. The batch process dialog then needs you to either add a folder or add images to then be able to start the split process and then set the parameters for each stack. I then open the batch process dialog and cant for the life of me figure out how to get this to all work. When I send a large number of images containing multiple stacks to Helicon from LR they open under the source image dialog, on the right side of the screen as is usual. Problem is I am beginning to think Batch process in Helicon won't work if you are sending images from LR. I would much prefer now to send images from LR to Helicon and use batch process to separate them into groups, put in the parameters and then let the computer do its work whilst I do other things. The problem is I am shooting a dramatically increasing number of stacks. Then import a new group of images to LR and repeat. Set the parameters, render and sending the resulting image back to LR as a DNG. For several years I have sent my images to be stack, one group at a time. First let me state I have read the documentation, searched online forums and contacted Helicon support (no response). ![]()
0 Comments
Leave a Reply. |